Every square inch of the inside is welded up if that is what it takes

Cracks and washouts are excavated to the bottom and welded 100%

Stud holes are drilled out and welded up, as many as are required

Most of the machining is done on late model CNC equipment

Sometimes it takes a lot of weld... 400# of wire is unusual, but not unheard of

We chase and "wobble test" each stud hole to determine if the threads are good

Each part is stress relieved after welding. We hold 'em 7 hours at 1250 degrees

Nasty washouts in the wear plate area, close to an inch deep.

Extensive erosion and crack above suction seat fit. Some cracks are 3" + deep.

Washout in and below discharge seat fit

Snyder Wilson pump pod weighs about 4400#

Rebuild of Fluid Ends for Triplex Pump

There is a lot of work in the refurbishment of these fluid ends, but when we are finished with them, they are in like-new condition again.